article In Australia, polyethyles are still used to coat some garments, but are now being phased out.

The change comes after a number of studies found they were causing skin and eye damage, and even causing lung cancer.

The Australian Government announced a $1.2 billion package of funds to tackle the issue.

But that doesn’t mean Australia’s textile industry is in a position to compete with the global market, which has a huge market for polyester.

And some are calling for more research to find out if polyethylen is a safer material.

ABC News visited the factories in Australia where polyethylens are made and found that they are not always safe.

In some cases, they are made using a synthetic material that is toxic to workers.

Polyethylen products are used on the outer layer of clothing, such as hats, coats and shoes.

However, in others, such products are made with the outer polyester lining on, so workers don’t get the full benefit.

ABC Radio Queensland’s Ben Whitehead, who recently visited Polyethylenes factory in Darwin, says the company does a lot of testing on workers before they start the process.

“So, they’ll do a test run, and they’re like, ‘OK, do you want to wear this?’

And they’ll say, ‘No, no, no.’

And they say, “Well, we’ll test it again, and it will be better for you.'”

It’s not clear how long polyethylenic polyester will be used, but it’s not a safe material.

A report published in 2017 by the US National Institute for Occupational Safety and Health found polyethyleninges could cause serious lung and lung-related diseases.

The researchers found polymers used in polyester were more likely to cause skin irritation and irritation of the skin, as well as breathing problems.

Polyester is a high-quality synthetic that is a popular material in the clothing industry.

It’s used on many types of clothing in Australia, including clothing, apparel, footwear, and clothing accessories.

It is also used in some other countries.

But in Australia polyester is also often sold as polyethylethylene (PE), which is a cheap, cheap, low-quality polyester that is widely used.

The most common PE materials in Australia are from the US, Japan and China.

The International Labor Organization (ILO) has estimated that there are about 10,000 workers who are exposed to PE.

PE is more expensive than polyethylenediaminetetraacetic acid (PEA), which has the same properties as PE.

It also contains methylcellulose and is a highly flammable, irritant.

The PEA industry is largely unregulated in Australia.

While the industry is still growing, and Australia has a large manufacturing base, it’s only growing at a much slower rate than in other countries where it’s used.

The ABC visited a factory in the Sydney suburb of North Ballarat. “

There’s a concern that the industry will be growing too fast, that it’s going to get worse and worse, and people are going to have to be more vigilant about wearing polyethyleners,” said Ms Whitehead.

The ABC visited a factory in the Sydney suburb of North Ballarat.

Workers at the Polyethylens factory told the ABC that they were given little warning about the use of PEA and other PE materials.

The company’s manager, Ravi Raj, told the factory’s owner that the workers were told that the company was manufacturing polyethylener dyes for the Australian military.

“They were told, ‘Don’t worry, it’ll be OK, it will last for about 15 years,’ and it did,” Mr Raj said.

“When we asked them if they thought it would cause any problems, they said ‘No problem, just don’t worry’.” The ABC also visited Polyethane Polyester Manufacturing in South Australia’s South West, which is one of the largest suppliers of polyethylhenes to the Australian industry.

The workers at the plant told the company’s owner they were told to wear polyethylENA masks to reduce exposure to PEA.

Mr Raj told the Australian Broadcasting Corporation that Polyethne was not always tested properly and that there was a problem with the use.

“We don’t know exactly how long PEA has been used,” he said.

He said the company is testing the company products daily and would be able to provide more information in a few weeks.

In the end, Mr Raj and the workers decided to wear masks for the safety of their company and the environment.

However it’s unclear how long Polyethyne will be in use in Australia and whether it will stay around for long.

In 2017, Australia’s Product Safety Commission found that polyethylylene was “incompatible with safety standards” for use in the workplace. It found